Transit Log: San Francisco, CA

SF is one of the easiest articles to write, because the transit generally works how you expect.

Set up Clipper on your phone (Apple Wallet: click + then Transit Card). Once you have Clipper set up, you can ride pretty much anything. You add a balance to the card in Apple Wallet, and it just deducts the right amount, automatically figuring out distances, transfers, etc. It’s pretty seamless (except on the cable car; I had to open Clipper in my wallet to get it to scan right). Keep at least $10 balance and you’re good most anywhere.

You can also do a physical card, but I find the phone app super convenient, especially when I need to add value.

There are a lot of different transit agencies and routes, and it can be a bit confusing which to take. The Transit app is pretty great at finding you an efficient route. If you’re downtown, you might be able to take bart, a fast Muni Metro train, a slower above-ground Muni Metro streetcar, a bus, or a cable car to get to your destination.

Just tap on, and you’re good to go. Bart and CalTrain have distance-based fares so you have to tap again when you get off. There might be a higher authorization on your card for a bit, which gets refunded once you tap off.

Muni Metro is interesting; downtown you’ll tap at the station, but if you’re further away you’ll tap the reader as you enter the train. As long as you’ve tapped at one time or another you’re fine.

The ferries are a bit tricky to find. I don’t know if it’s due to construction or if it’s normal. If you’re at the ferry terminal, on your right is a cluster of buildings for Golden Gate Ferry. The ferries do not leave from that building. They leave from a different pier on the left. Once you find that, the employees will separate you into an appropriate queue.

The signage for the ferries is poor, and there are a lot of unwritten rules. I saw ferry employees getting upset with bicyclists for standing slightly to the right instead of to the left when they were in line.

I think there are other ferry companies to other destinations, but I didn’t ride them.

The ferries are very nice, plenty of seating, onboard electrical outlets for you to charge your devices, small bar with food and drinks and I think booze.

Sausalito is an absolute tourist trap. But that has nothing to do with transit.

Cable cars are kinda a tourist thing, not terribly fast, but great at hills, and really fun to ride. The fare, at 8 bucks, is as steep as the hills it climbs. Har har har.

It took a WHILE for the car to come, and a while longer for it to depart. They really aren’t concerned with efficiency or frequency here.

There’s a $13 day pass as well. I don’t know if Clipper will automatically figure that out and just charge you $5 for your second ride, or if you should buy a separate day pass ticket instead. A driver or attendant could probably answer that question. I just rode once; when we departed, an employee came around with a handheld reader for Clipper. Unlike all my other Clipper trips, for this one I had to open my wallet and have Clipper on-screen for it to work (it tried to pull up my credit card instead).

The Muni Metro trains are pretty amazing. They run underground downtown with raised platforms, and outside of downtown they run at street level, and you need to walk up stairs to get in. When the train goes from underground to above-ground. the inside of the car, by the doors, converts from flat to stairs, making a cautionary beep beep beep.

In general, these are pretty efficient. I rode one all the way to the end of the line in Ocean Beach, and the ride was pretty monotonous, felt like it stopped too much and took longer than I expected. But it got me there. And it’s kinda just a product of the geography. If you’re in a flat area, you can put stops several blocks apart, but with how hilly SF is, each further block between stops is a big schlep.

CalTrain is longer-distance regional rail. I didn’t ride it on this trip, but I’ve ridden it in the past, between downtown, San Jose, and SF International Airport. It’s easy, fast, and efficient. Tap with Clipper as you get on, expect a fare checker to scan your phone (or whatever you paid with) during the journey, and tap when you get off.

Have some extra value on Clipper if you’re riding CalTrain. If I recall correctly, it temporarily charges you the amount of the longest trip possible when you board. Then when you exit, it calculates your actual fare and refunds you the difference.

Make extra sure that you tap on the way out, or you’ll be charged for a longer trip than you took.